Programme Degree of soil Cycle Description
Recommended
quantity of
detergent
pre-wash /
main wash
Washing
time
(min.)
Energy
(Kwh)
Water
(L)
Rinse
Aid
needed?
60 min
For lightly
soiled loads
that need
no excellent
drying
eciency
Hot rinse 1
Hot rinse 2
Hot rinse
(60°C)
Drying
5/20 g 60 0�95 10 Yes
Rapid
A shorter
wash for
lightly soiled
loads and
quick wash
Main wash
(40°C)
Hot rinse
15 g 39 0�50 7 No
Pre-rinse
To rinse out
loosen soil
particles
from the
dishes
Pre-wash NA 11 0�01 4 NA
* Testing programme for EN 50242
The information for comparability test in accordance with EN 50242 is
as follows:
• Capacity: 12 settings
• Position of upper basket: Low position
• Rinse aid setting: 5 (or 4 for four setting dispenser
NOTE:
1� The washing time may vary depending on the incoming water
temperature and the ambient temperature�
2� The power consumption in left-on mode is 0�9W (door open),
in o-mode it is 0�35W�
1� Turn the water tap on�
2� Open the dishwasher door�
3� Check the lters�
• Ensure they are clean and properly positioned� See “Cleaning
and maintenance” section�
4� Check that there is rinse aid and salt�
5� Load the dishes�
• Ensure that the spray arms can rotate freely�
6� Add the required amount of detergent into the dispenser
according to the “Washing Programmes” chart�
7� Close the dishwasher door securely�
8� Press to switch on the dishwasher�
9� Select the desired washing programme by repeatedly pressing
• The corresponding washing programme indicator light will
ash�
• Delay : The delay start function allows you to delay the start
of a washing programme from 1 hour to a maximum of 24
hours�
Repeatedly press until the desired start delay
time ashes on the display, e�g� 3H for a 3-hour delay�
Once the delay timer has been set, press to
activate the function�
The corresponding start delay time will stop ashing�
10� If you use 3-in-1 tablet, press 3-in-1 to select the 3 in 1-tab
Starting the Dishwasher
5756
To Next Page
Loading...
Need help?
General
