Warranty
Make sure your kit meets one of the following VESA standards: 200 x 200 mm.
The kit is not included in the
package. To do this, follow the steps below to remove the bracket:
1. Turn off the TV and disconnect all cables and connectors. For the following steps,
you will need a classic
Phillips screwdriver.
2. Spread the soft cloth on an empty horizontal table and carefully lower the TV screen.
3. Loosen the bracket fixing screw. See also the Basic Installation Guide (provided).
The stand is now removable.
4. Install the VESA wall mount on the back of the screen. Follow the installation instructions
that came with the
wall bracket kit.
WARNING: Make sure that the wall plugs and screws
you used to secure the unit to the wall are strong enough
to support the weight of the unit. Also make
sure the wall material is strong enough.
Keep the base, the stand and the screws in a safe place in case you need to
reassemble the base again. If necessary, you can also disassemble the base
so it takes up less space.
To Next Page
Loading...
