Saber Compact R67SC0012

To Next Page

Have Questions? Need Assistance?

Call us at 1-866-671-7988

An instructional video demonstrating this procedure is available at www.saberGrills.com/Support/Article.aspx?articleid=348

Des questions? Avez-vous besoin d'aide?

Appelez-nous au 1-866-671-7988

Une vidéo expliquant cette marche à suivre est mise à votre disposition au www.saberGrills.com/Support/Article.aspx?articleid=348

¿Tiene preguntas? ¿Necesita asistencia?

Llámenos al 1-866-671-7988

Puede ver el video instructivo que describe este procedimiento en: www.saberGrills.com/Support/Article.aspx?articleid=348

For Model Numbers: / Pour les numéros de modèle : / Para los números de modelo:

R33CC0312, R33SC0012,

R50CC0312, R50CC0612, R50SC0012, R50C1715

R67SC0012

English: Pages 2-12

Français: Pages 13-24

Español: Páginas 25 36

CONTROL PANEL & SIDE

BURNER REPLACEMENT

Estimated time to complete this replacement: 1 hour.

Saber Grills Recall September 2017

Replace the components as instructed below to prevent the following hazard:

The grills’ LP regulator can allow gas to ﬂow at a higher pressure than intended, which can result in a

gas leak and ﬂame burst from the burner knobs, posing ﬁre and burn hazards to consumers.

Printed in U.S.A.

80028080 ● 09/13/17 ● Revision 03

sabergrills.com

Other manuals for Saber Compact R67SC0012

Assembly Instructions And Rules2 pages

Need help?

Do you have a question about the Saber Compact R67SC0012 and is the answer not in the manual?

Summary

Control Panel Replacement Preparation

Pre-Replacement Checklist

Essential steps before starting the control panel replacement procedure.

Tools and Safety Gear for Panel Replacement

List of tools and safety equipment required for the control panel replacement.

Removing the Existing Control Panel

Thermometer, Knob, and Bezel Removal

Steps to remove thermometers, control knobs, and bezels from the panel.

Disconnecting Gas Line and Wires

How to disconnect the side burner quick-connect and ignitor/light wires.

Physical Removal of Control Panel

Procedures for removing retaining screws and lifting the control panel assembly.

Installing the New Control Panel

Preparing and Connecting New Panel Wires

Steps to prepare the new panel and reconnect ignitor and light switch wires.

Securing and Reassembling Control Panel

How to attach the new panel, reinstall screws, bezels, and knobs.

Final Control Panel Installation Steps

Inserting thermometers and finishing the control panel replacement.

Side Burner Replacement Procedure

Removing the Old Side Burner

Instructions for removing the side burner grate, electrode wire, and shelf.

Installing the New Side Burner

Guidance on installing the new side burner shelf and reconnecting its components.

Reinstalling Side Burner Knobs and Connections

Reattaching side burner bezels, knobs, and ensuring secure connections.

Performing the Leak Check

Leak Check Preparation and Materials

Necessary materials and setup for conducting the leak check procedure.

Leak Check Procedure and Safety Warnings

Detailed steps for checking for gas leaks and important safety warnings.

Final Steps Before Grill Use

Reinstalling the grease tray and confirming the grill is ready for use.