What to do if there is a grease fire in my Saber Compact Grill?
If you experience a grease fire or continuous excessive flames, immediately turn OFF the control knobs and the LP cylinder valve. Leave the lid open to allow the flames to die down. After the grill has cooled, clean any food particles and excess grease from inside the firebox area, grease tray, and other surfaces.
What to do if there is a fire coming through the control panel of my Saber Compact R50CC0612?
If you see fire coming through the control panel, immediately turn OFF the control knobs and the LP cylinder valve. Leave the lid open to allow the flames to die down. Once the fire is out and the grill is cold, remove the burner and inspect it for spider nests or rust. See Natural Hazard and Cleaning the Burner Assembly pages.
What to do if gas is leaking between the LP cylinder and regulator connection on my Saber Compact R50CC0612?
If you notice a gas leak between the LP cylinder and the regulator connection, turn OFF the LP cylinder valve. Then, remove the regulator from the cylinder and visually inspect the rubber seal for any damage. See LP Cylinder Leak Test and Connecting Regulator to the LP Cylinder.
What to do if gas is leaking from the LP cylinder valve of my Saber Compact R50CC0612?
If gas is leaking from the LP cylinder valve, immediately turn OFF the LP cylinder valve and return the LP cylinder to your gas supplier. This is due to a failure of the cylinder valve from mishandling or mechanical failure.
What to do if gas is leaking from the LP cylinder of my Saber Compact R50CC0612 Grill?
If gas is leaking from the LP cylinder, replace the LP cylinder. This is likely due to mechanical failure caused by rusting or mishandling.
How to fix gas leaking from the hose of my Saber Compact R50CC0612 Grill?
If gas is leaking from a damaged hose (cracked, cut, or burned), turn OFF the gas at the LP cylinder. If anything got burned, replace the valve/hose/regulator. If burned, discontinue use of the product until a plumber has investigated the cause and corrections are made.
Why won't the burner light on my Saber Compact R50CC0612 Grill using the ignitor?
There could be several reasons why the burner won't light. Here are some things to check: * **Gas Issues:** Ensure you're trying to light the correct burner, the burner is engaged with the control valve, there are no obstructions in the burner, there is gas flow, there's no vapor lock, and the coupling nut and LP cylinder valve are fully connected. * Refer to instructions on the door panel and in the Use and Care section. Position valves inside of burner tubes. Ensure burner tubes are not obstructed. See cleaning section of Use and Care. Make sure LP cylinder is not empty. If LP cylinder is not empty, refer to 'Sudden drop in Gas Flow.' Turn OFF knobs and disconnect coupling nut from LP cylinder. Wait 30 seconds, reconnect and retry. Turn the coupling nut approximately one-half to...
General| Number of Burners | 3 |
|---|---|
| Ignition System | Electronic |
| Fuel Type | Propane |
| Primary Cooking Area | 500 sq. in. |
| BTU Output | 24000 BTU |
| Grate Material | Stainless Steel |
To Next Page