To Next PageTo Next Page
Need help?Do you have a question about the Sabiana SK 44 and is the answer not in the manual?
General| Brand | Sabiana |
|---|---|
| Model | SK 44 |
| Category | Air Conditioner |
| Language | English |
Highlights particularly important, delicate, or dangerous operations requiring attention.
Lists environments where the unit must not be installed (explosive, corrosive, humid, outdoor).
Emphasizes following laws, regulations, codes, and technology for installation and maintenance.
Stresses the need for trained personnel and clear definition of responsibilities for electrical/hydraulic work.
States that all repairs and maintenance must be done by specialized and qualified personnel.
Any modification affecting safety requires manufacturer approval.
Instructions to remove fan lock, install safety switch, and ensure proper earthing.
Warns against installation in explosive, corrosive, damp environments, or outdoors.
Outlines critical safety measures like handling by two people and using adequate lifting equipment.
Emphasizes using original parts, work gloves, and disconnecting power before any work.
Strict warning about dangerous voltage and the need to disconnect power and wait for capacitor discharge.
Mandates following all safety and technology regulations during installation and maintenance.
Advises on preventing air stratification and positioning outlet grills for downward airflow.
Provides steps for marking, drilling, fixing rods, and securing the unit, emphasizing horizontal alignment.
Instructs to check fan operation at all speeds before activating electric heaters.
Details the two safety thermostats (manual/automatic reset) and their role in preventing overheating.
Outlines requirements for open circuits, water quality, filtration, and protection against corrosion.
Covers using spanners, installing shut-off valves, and water shut-off during summer inactivity.
Advises considering leakage current for electronic appliances and calculating total leakage based on installed units.
Mandates placing the controller exclusively inside the metal shunt panel to ensure compliance.
Details the two safety thermostats and their role in preventing overheating and interrupting power.
Covers cable routing, valve connection according to diagrams, water shut-off function, and critical contact timing.
Crucial safety advice to disconnect power before any cleaning or maintenance operations.
Addresses issues like fan not running or running incorrectly, and lists possible causes and corrective actions.
Covers problems with the unit not heating or cooling sufficiently and their solutions.
Details causes and remedies for water leaks, including condensate drain issues.
Lists common fan issues (not starting, low airflow, noise) with causes and corrective actions.
Addresses insufficient heating or cooling, low water flow, and incorrect setpoint issues with solutions.
Covers leaks during cooling mode, condensate drain problems, and unstable room temperature causes/remedies.
