SACKit Go 300 - How to use DAB+; Change Settings; Battery Information

7
How to change settings on SACKit Go 300
1. Press and hold the Mode/Menu buon (C) to open the sengs.
2. Use the Arrow buons (<) or (>) to navigate to System.
3. Use the Power buon (B) to conrm.
4. To go back or exit the menu, press the Mode/menu buon (C).
There are four opons to choose from under System:
• Time: The me and date displayed by SACKit Go 300 will set itself through the DAB+ signal. How-
ever under this seng it is possible to turn this feature o and set it manually instead.
• Backlight: Here you can choose the brightness of the display and even set a meout on it for when
it is idle.
• Factory Reset: This opon lets you reset the device to its factory sengs.
• SW Version: Will display the current soware version installed on the SACKit Go 300.
How to use DAB+
Make sure that the radio antenna is extended before entering DAB+ mode.
1. To enter DAB+ mode, press the Mode/Menu buon (C) unl ”DAB” is displayed.
2. SACKit Go 300 automacally connects to the strongest DAB+ channel.
3. Press the le arrow (<) or the right arrow (>) to toggle between the radio channels.
4. Pressing the Power buon (B) while in DAB+ mode, will mute/unmute SACKit Go 300.
If the SACKit Go 300 is in DAB+ mode, the sengs menu will oer more opons. You navigate the
menu like this:
1. Press and hold the Mode/Menu buon (C) to open sengs.
2. Press the le arrow (<) or the right arrow (>) to toggle between the menu’s four opons (Full scan,
Manual tune, Prune and System).
3. Use the Power buon (B) to conrm.
4. To go back or exit the menu, press the Mode/Menu buon (C).
• Full scan: SACKit Go 300 will scan all the channels in alphabecal order.
• Manual tune: Press the le arrow (<) or the right arrow (>) to toggle between all channels between
5A - 13F. Then press the Power buon (B) to conrm.
• Prune: Deletes any invalid DAB+ channels.
• System: When entered, four more opons appear (Time, Backlight, Factory Reset, SW Version).
Battery information
• Baery: rechargeable Polymer Lithium-Ion Baery, 2200mAh.
• Power: 5V DC 0.5-3A via USB-C.
• Charging Time: Please be sure the baery has been fully charged before rst use. It can take up to
3 hours of charging the rst me, but 2 hours normally with a 5V 3A adapter.
• When the device is on, the display on top of the SACKit Go 300 will show the baery status.