SACKit Go 300 - The Device; Getting Started; How to use Bluetooth; Disconnect Bluetooth

6
How to use Bluetooth
1. To enter Bluetooth mode, press the Mode/Menu buon (C) unl ”BT” is displayed. The screen will
then display ”Connecng” and a voice will say ”Bluetooth mode”. SACKit Go 300 is now waing for
connecon.
2. Switch on Bluetooth on your device
3. Choose “SACKit Go 300” under Bluetooth sengs on your device. Your speaker is now connected
to your device.
4. Start playing music on your SACKit Go 300!
5. SACKit Go 300 will automacally pair with the last connected device
To connect to a new device make sure that the previous connected device is disconnected otherwise
connecng opportunies won’t appear on the new device.
THE DEVICE
How to use FM-radio
Make sure that the radio antenna is extended before entering FM mode.
1. To enter FM mode, press the Mode/Menu buon (C) unl ”FM” is displayed.
2. Press and hold the le arrow (<) or right arrow (>) to scan for channels. The scan stops automacally
when the next staon is found.
3. Alternavely, press the le arrow (<) or right arrow (>) to tune up or down between the channels at
0.05 MHz per tap.
4. Pressing the Power buon (B) while in FM mode, will mute/unmute SACKit Go 300.
Geng started
Follow these three simple steps to get started:
1. Charge SACKit Go 300 in the USB-C port (D) with the included USB-C charger cable.
2. Turn on SACKit Go 300 by holding down the Power buon (B).
3. Select the mode you want by pressing the Mode/Menu buon (C).
Note: It may be necessary to unfold the antenna on the back to get sucient signal when listening to
the radio.
Disconnect Bluetooth
You have to be in Bluetooth mode to disconnect.
1. To disconnect the Bluetooth connecon to a device, press and hold the le arrow (<) or the right
arrow (>) unl hearing ”Disconnected”.
2. SACKit Go 300 is disconnected and is now ready to pair to a new device.