Need help?Do you have a question about the SACKit WOOFit JAM and is the answer not in the manual?
Power| operation voltage | 3.7 V |
|---|---|
| charging voltage | 5V |
| output power | 2 x 5 Watts |
Speaker Specifications| speaker specification | 50mm 2 Ohms 5W |
|---|---|
| frequency response | 60HZ ~ 20 KHZ |
| snr | ≥ 90 dB |
Battery| lithium battery capacity | 2500 mA |
|---|---|
| thd | ≤ 0.5% |
Weight and Dimensions| item size | 60mm * 72mm* 196mm |
|---|
Connect the WOOFit JAM to your Hi-Fi system as a Bluetooth receiver.
Experience surprisingly rich sound from this compact speaker.
Use the WOOFit JAM as a microphone or for hands-free calling.
Ensures clear hands-free calls by enhancing sound and reducing echo.
Connect easily by touching your NFC-enabled device to the speaker.
Enjoy up to 15 hours of playback on a single charge.
Connect two WOOFit JAM speakers for an immersive stereo sound experience.
Stream music wirelessly from all units via Bluetooth.
Long press to turn the system on/off. Power indicator lights blue when on.
Adjust volume using the +/- buttons. Beep alert at max volume in Bluetooth mode.
Use PREV/NEXT buttons for previous/next song in Bluetooth mode.
Short press for Play/Pause. Long press for Bluetooth pairing.
Press M button to switch between Bluetooth and AUX modes.
Answer, reject, or switch calls using the Phone Button.
Connect headphones to the speaker. Sound adjusts gradually to protect hearing.
Connect to audio sources like computers or stereos for wireless playback.
Used exclusively for charging the device.
Turn on/off with the Power Button. Blue indicator for power on.
Connect via USB cable. Red indicator shows charging; light goes out when full. Takes 2 hours.
Buttons light up when motion is detected in low light conditions.
Steps to pair your device via Bluetooth, including pairing mode and device selection.
Input '0000' if a passcode, passkey, or PIN is required during pairing.
Turn on NFC on your device and bring it close to the speaker to connect.
Select AUX mode and connect source to AUX IN. Turn off Bluetooth to use AUX.
Steps for playing music via Bluetooth connection.
Use V+ / V- buttons for volume. Adjustable across all modes.
Use PREV/NEXT buttons to skip tracks during playback.
Connect two speakers wirelessly for stereo sound. Double press M button on both.
One speaker plays left, one plays right. Connected device plays left.
Resetting the speaker may fix connectivity issues or bad sound.
Hold PREV and NEXT buttons simultaneously to reset the device.
Short press the Phone Button to answer an incoming call.
Long press the Phone Button to reject or end a call.
Short press the Phone Button during a call to switch to another incoming call.
Check battery, power cycle speakers, or reset for sound/connectivity problems.
Press and hold PREV/NEXT buttons to reset for new pairing after issues.
Enter '0000' if prompted for a passcode, passkey, PIN, or password.
To Next Page
