CONTROL PANEL MESSAGES
PANNARELLO (OPTIONAL)
Flashing
Steadily lit
Flashing
Flashing
Steadily lit
Flashing
Steadily lit
Flashing
Load the circuit (Starting up)
Machine overtemperature. Place
a container under the steam
tube
and open the steam knob. When the lights remain on,
close the knob.
Descale the machine
Fill the water tank with fresh
drinking water.
Fill the coffee bean container
with coffee beans.
Fit the brew unit, drip tray and
dregs drawer correctly into
place. Close the front door.
Coffee grinder motor jammed.
Brew unit motor jammed.
Contact an Authorised Service Centre.
Open the door, remove the
dregs drawer and empty the
used coffee grinds into a suitable container.
Important note: the dregs drawer may be emptied only when
the machine is on. The drawer must be removed for at least
5 seconds. If you empty the drawer with the machine off,
you will not be able to dispense coffee the next time you
switch the machine on.
PANNARELLO
(OPTIONAL)
USING
Use the frothing nozzle like
the steam nozzle to make
wonderfully hot and creamy
Cappuccinos.
Proceed as with preparation
«STEAM/ CAPPUCINO»,
immerse nozzle approx. 3-4
cm/1-1.5” in the milk.
CLEANING
AFTER PREPARATION
Loosen the cap, remove
nozzle.
Clean with damp cloth.
Disassemble nozzle.
Place nozzle parts under run-
ning water and remove milk
residue.
Dry separate parts, reassem-
ble, and mount on machine.
To Next Page
Loading...
