Safavieh Outdoor Akita PAT7503 User Manual

NOTICE
* Please make sure that you have all parts indicated before you begin assembly of this item
* This item should be assembled on a soft surface to prevent scratching the finish during assembly
* This item may require periodic tightening
CARE AND MAINTENANCE
Spills should be taken care of immediately before they harden or
stain with a slightly dampened sponge.
Part List and Hardware List
QUANTITY
PIECE DESCRIPTION
Plastic washer
Allen bolt(M6x40 mm)
Allen key
PICTURE
1
1-3
2
3
4
5
A
B
C
D
1X
1X
1X
1X
1X
4X
4X
1X
Table top frame
Table long leg
Table short leg
Table side leg 1
Table side leg 2
Allen bolt(M6x60 mm)
E
F
G
Spanner
1X
Nut M6
Steel washer
8X
Weight Capacity : 275 Lbs (single seat)
550 Lps (towperson seat)
Warning : Do not stand on table
Warning : Do not over torque bolts/screws
16X
8X
Store outdoor furniture indoors or cover well when not in use.
Remove wicker furniture from standing water. Dust regularly with small brush or vacuum
Model# PAT7503
Product Dimensions: 31.50"x55.12"x28.35" H

Safavieh Outdoor Akita PAT7503 Specifications

General

Product Name	Safavieh Outdoor Akita PAT7503
Category	Outdoor Furnishing
Material	PE Wicker
Style	Contemporary
Cushion Material	Polyester
Weight Capacity	250 lbs

Summary

Care and Maintenance

General Care Instructions

Store outdoor furniture indoors or cover when not in use. Remove wicker furniture from standing water. Dust regularly with brush or vacuum.

Spill Management

Address spills immediately before they harden or stain with a slightly dampened sponge.

Assembly Notice

Pre-Assembly Checks

Ensure all parts are present before beginning assembly. Assemble on a soft surface to prevent scratching.

Periodic Tightening

This item may require periodic tightening of fasteners after assembly.

Part List and Hardware

Component Identification

List of parts including table frame, legs, bolts, nuts, and washers with their quantities.

Preparation and Tools

Pre-Assembly Verification

Verify all parts against the package contents list and hardware list before assembly.

Included Assembly Tools

Tools required for assembly include an Allen Key.

Assembly Steps

Step 1: Connect Legs

Connect short leg and side legs, then tighten bolts, nuts, and washers using Allen Key and Spanner.

Step 2: Attach Long Leg

Connect the assembly from Step 1 to the long leg, tightening with Allen Key and Spanner.

Step 3: Secure Table Top Frame

Connect the assembled base to the table top frame using bolts, nuts, washers, Allen Key, and Spanner.