INSTALLATION
On delivery, check whether the packing box is damaged Report any
damage immediately to the delivery agent Check whether the power
cord sent is suitable for your voltage requirements
Assemble the machine in the following manner:
• Take the machine out of the box The power cord should
be passed through the power cord pull reliever
(see photo below)
• Insert the hose into the machine
• The tubes are inserted into each other where the hose is
mounted
Check to see whether a dustbag has been inserted For this, read the
instructions under the heading;
"REMOVING AND REPLACING THE DUSTBAG"
Don’t use the machine if no dustbag is inserted a may
damage the machine
OPERATION OF THE MACHINE.
Note: This machine is designed for a mains voltage
of 230 volts.
Powercord / light indicator
This machine is equipped with an on/off switch with a light indicator
The switch should light after it receives mains voltage If this does
not happen, check the power cord, or change the mains power cord
Instruction Manual
ESD
Page 3
Attention
This is a ESD Vacuum Cleaner
Every part is ESD approved
Replace parts only with ESD approved materials!!
To Next Page
Loading...