Installing the Child Safety Seat - Forward Facing
For use with GROUP 1 - from 9 to 18 kgs (approx. 4 years)
Installation Checkpoints - Forward Facing
The vehicle seat belt has been
pulled tightly and is not twisted
The vehicle seat belt is
fed through the slots in
the shell of the Child
Safety Seat
The vehicle seat belt is
fed through the slots in
the shell of the Child
Safety Seat
The Child Safety Seat is
pushed back into the
vehicle seat
Place the Child Safety Seat firmly against the back of
the vehicle seat
Pull the vehicles 3-point safety belt through the back
of the shell between the plastic of the shell and the
cover and fasten the seat belt into the buckle.
Ensure that the lap belt section goes through the two
red guide clips on both sides of the base.
Red Clip
Buckle
Pull hard on diagonal belt strap to tighten the lap belt
strap over the Child Safety Seat and place the Red
Clip over the diagonal belt as close as possible to the
vehicle buckle. ONLY PLACE THE RED CLIP OVER
THE DIAGONAL BELT, NOT BOTH.
Fastening the Child Safety Seat Buckle
Fasten the buckle by bringing the two tongues of the harness straps
together and pushing them into the buckle until a click is heard.
6
To Next Page
Loading...
