Saft Ni-Cd - Operation Procedure; Watering Cart Operation

Watering cart equipment
G The battery for the watering cart
is shipped disconnected. Before
using the cart, connect the
battery according to supplied
instruction.
G Remove the cap and fill tank with
ONLY distilled or de-ionized
water (per IEC 60993). Replace
the cap when full.
G Connect the output hose of the
watering cart to the bottom of
the filling pistol’s handle. A quick
connector is preassembled.
G Turn the power switch to the ON
position. The switch is located
on the back of the cart. The
pump will energize for a few
seconds and then stop.
G Refer to “Filling pistol operation”
(page 3).
G Once all topping-up is complete,
turn the power switch to the OFF
position.
G Charge the cart battery as
needed. The battery needs
13 hours to fully charge.The
battery shall be kept at a good
level of charge.
Note:
• The watering cart cannot be
operated while the charger is
connected to the battery.
• The expected run time of the
watering cart, with a fully
charged battery, is 2 hours
continuous. Longer run times
are likely with intermittent use
of the system.
Easy to maneuver:
handles like a hand truck
Easy to use:
instructions right on the unit
Easy to fill:
large opening
On/off switch
Sealed cell battery:
included
Output hose
Dependable water source
Watering cart equipment
Container capacity 38 L (made in polypropylene)
Charger 120 V / 230 V with exchangeable AC plug models
Hose ≈ 3.2 m in length
Battery 12 V / 7.2 Ah
Dimensions (mm) 150 x 64 x 94 (LxWxH)
Dimensions (mm) 432x432x940(LxWxH)
Packaging dimensions (mm) 413x413x940(LxWxH)
Weight 14 kg (empty)
52 kg (full)
Operation procedure