Need help?Do you have a question about the Saft SBM and is the answer not in the manual?
Designed for long discharge periods with low current, typical for power backup.
Suited for sustaining loads between 30 minutes to 3 hours or mixed loads.
For applications demanding high current over short periods, less than 30 minutes.
Guidance on selecting battery types based on discharge time and voltage requirements.
Defines acceptable maximum and minimum battery voltages for system compatibility.
Specifies electrical performance requirements, expressed in amperes, power, or duration.
Addresses the influence of ambient temperatures on battery sizing and performance.
Covers requirements for achieving a full duty cycle after a discharge.
Covers general charging methods, constant voltage, and effects of overcharging.
Details two-rate and single-rate floating voltage systems for charging.
Covers tolerance to ripple currents, over-discharge, and overcharge impacts.
Details shock load, vibration resistance, and external corrosion protection.
Instructions for checking batteries upon receipt and initial storage conditions.
Describes the purpose and application of cell oil to reduce self-discharge.
Procedures for keeping cells clean, checking terminals, and protecting them.
Guidance on checking electrolyte levels and using approved water for topping-up.
General| Brand | Saft |
|---|---|
| Model | SBM |
| Category | Battery Pack |
| Language | English |
To Next Page
