To Next PageTo Next Page
Need help?Do you have a question about the Saftronics DG2 PLUS Series and is the answer not in the manual?
General| Frequency | 50/60Hz |
|---|---|
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Short Circuit |
| Communication Interface | Modbus RTU |
| Storage Temperature | -20°C to +65°C |
| Humidity | 5-95% non-condensing |
Provides a general overview of the DG2 PLUS series thyristor controllers for DC motors.
Details the key features and capabilities of the DG2 PLUS series motor speed controls.
Outlines the electrical parameters including power, speed range, load regulation, and acceleration/deceleration.
Covers electrical protection mechanisms such as fusing and surge suppression.
References dimensional information for the DG2 PLUS series.
Details control adjustments (RV1-RV7) and includes a critical safety caution for RV4.
Specifies environmental conditions and placement requirements for DG2 PLUS unit installation.
Provides information on how to derate the unit based on ambient temperature and altitude.
Outlines wiring connections according to NEC and customer area electrical codes, including grounding.
Guides through pre-application inspection, including AC input and field voltage selection.
Covers pre-start adjustments, tachogenerator setup, and preventing drive runaway.
Details the steps for safely starting the motor and setting minimum and maximum speeds.
Illustrates the wiring for DG2P-10 and DG2P-15 models.
Presents the wiring diagram specifically for the DG2P-25 model.
Shows the wiring configuration for torque control applications.
Details the internal schematic of the AA1128 control card.
Illustrates motor connections for permanent magnet and wound field DC motors.
Provides dimensional drawings for the DG2P-10 and DG2P-15 models.
Presents the dimensional specifications for the DG2P-25 model.
Shows the external dimensions for the enclosed DG2P-10, 15, and 25 units.
