Why is the operating distance of my Saga saga1-l4 Controller shorter than expected?
The operating distance of your Saga Controller might be shorter than expected, or the operation might be intermittent because of interference from another Radio Remote Controller or an unknown signal using the same frequency. To resolve this, replace the crystal of both the transmitter (TX) and receiver (RX) to change the frequency.
What to do if red LED is flashing quickly on Saga Controller?
If the red LED is flashing quickly (every 0.2 seconds) when any motion pushbutton on the Saga Controller's transmitter is pressed, it could be due to: * One of the pushbuttons being jammed (in this case, replace the pushbutton). * The system not being properly powered. If this is the cause, power it on again according to the instructions.
What to do if TX LED flashes red and yellow on Saga saga1-l4?
If the TX LED on your Saga Controller flashes red and yellow reciprocally and slowly (every 0.5 seconds), it indicates that the memory of the TX is defective. In this case, send it back to the manufacturer.
What to do if RX Error LED flashes red on Saga saga1-l4?
If the RX Error LED on your Saga Controller flashes red slowly (every 0.5 seconds), it means that the memory of the RX is defective. In this case, send it back to the manufacturer.
Provides diagrams for DC and AC types of the relay board.
Explains optional independent COM lines for SAGA1-L series models.
Details receiver/decoder board, crystal replacement, and sensitivity adjustment.
Steps for installing the SAGA1-L function setting program from CD-ROM.
Instructions on launching the SAGA1-L function setting program from the Start menu.
Overview of the toolbar functions including Load, Save, Print, and Exit.
Details on connecting the interface cable and operating the software.
Explains function settings and definitions for PC software usage.
General| Brand | Saga |
|---|---|
| Model | saga1-l4 |
| Category | Controller |
| Language | English |
To Next Page
