Why is the operating distance of my Saga Controller shorter than expected?
The operating distance of your Saga Controller might be shorter than expected, or the operation might be intermittent because of interference from another Radio Remote Controller or an unknown signal using the same frequency. To resolve this, replace the crystal of both the transmitter (TX) and receiver (RX) to change the frequency.
What to do if red LED is flashing quickly on Saga Controller?
If the red LED is flashing quickly (every 0.2 seconds) when any motion pushbutton on the Saga Controller's transmitter is pressed, it could be due to: * One of the pushbuttons being jammed (in this case, replace the pushbutton). * The system not being properly powered. If this is the cause, power it on again according to the instructions.
What to do if TX LED flashes red and yellow on Saga Controller?
If the TX LED on your Saga Controller flashes red and yellow reciprocally and slowly (every 0.5 seconds), it indicates that the memory of the TX is defective. In this case, send it back to the manufacturer.
What to do if RX Error LED flashes red on Saga saga1-l8b?
If the RX Error LED on your Saga Controller flashes red slowly (every 0.5 seconds), it means that the memory of the RX is defective. In this case, send it back to the manufacturer.
Details the layout of the relay board for SAGA1-L series, including DC type specifications and fuses.
Step-by-step guide to installing the SAGA1-L function setting software from CD-ROM.
General| Brand | Saga |
|---|---|
| Model | saga1-l8b |
| Category | Controller |
| Language | English |
To Next Page
