Why is the operating distance of my Saga Controller shorter than expected?
The operating distance of your Saga Controller might be shorter than expected, or the operation might be intermittent because of interference from another Radio Remote Controller or an unknown signal using the same frequency. To resolve this, replace the crystal of both the transmitter (TX) and receiver (RX) to change the frequency.
What to do if red LED is flashing quickly on Saga saga1-l6b Controller?
If the red LED is flashing quickly (every 0.2 seconds) when any motion pushbutton on the Saga Controller's transmitter is pressed, it could be due to: * One of the pushbuttons being jammed (in this case, replace the pushbutton). * The system not being properly powered. If this is the cause, power it on again according to the instructions.
What to do if TX LED flashes red and yellow on Saga saga1-l6b?
If the TX LED on your Saga Controller flashes red and yellow reciprocally and slowly (every 0.5 seconds), it indicates that the memory of the TX is defective. In this case, send it back to the manufacturer.
What to do if RX Error LED flashes red on Saga saga1-l6b Controller?
If the RX Error LED on your Saga Controller flashes red slowly (every 0.5 seconds), it means that the memory of the RX is defective. In this case, send it back to the manufacturer.
Step-by-step guide for setting the ID-Code between transmitter and receiver.
Provides critical warnings and notes regarding ID-Code remote setting failures and limitations.
Guides on connecting the software to the transmitter/receiver and reading/writing data.
Explains remote ID-Code changing via transmitter within 4 minutes of power-on.
Details the settings for the 'Start Key' function, including Normal and Toggle modes.
Explains 'R/C' function settings like ID-Code Remote Setting and Power On Mode.
Allows enabling or disabling the ID-Code change via remote control.
Configures how the main relay is activated upon power-on using any pushbutton or start key.
Describes various settings for Up/Down pushbutton behavior (Normal, Toggle, Off/On).
Covers transmitter settings like Transmit Mode, Power Saving, and Save-Power.
Details receiver settings like Passive Act and Auto Off.
General| Brand | Saga |
|---|---|
| Model | saga1-l6b |
| Category | Controller |
| Language | English |
To Next Page
