Why is my SAGEMCOM DVR remote control not working?
If your SAGEMCOM DVR remote control isn't working, try these steps: Ensure the receiver is in the correct mode by pressing the EXIT key. Point the remote control directly at the receiver. Verify the batteries have sufficient life and are correctly inserted.
What to do if my SAGEMCOM DVR receiver cannot find any channels?
If your SAGEMCOM DVR receiver isn't finding any channels, verify the cable connection is secure. It is also recommended to check the cable signal reception. You can also search for programs again.
What to do if my SAGEMCOM DVR receiver displays a black screen or an error message?
If your SAGEMCOM DVR receiver shows a black screen or an error message, try searching for programs. This might resolve the issue.
Why is the picture frozen or unclear on my SAGEMCOM DVR?
If the picture on your SAGEMCOM DVR is freezing or unclear, check all the connections to ensure they are properly connected. Also, inspect the antenna and try searching for programs again.
What to do if there is no sound in HOME CINEMA mode on some channels with my SAGEMCOM DVR?
If you're experiencing no sound in HOME CINEMA mode on certain channels with your SAGEMCOM DVR, ensure that the receiver is connected to your HOME CINEMA amplifier using the optical SPDIF connection.
What to do if my TV set does not detect the SAGEMCOM DVR receiver when it leaves standby mode?
If your TV isn't detecting the SAGEMCOM DVR receiver after it exits standby mode, confirm that the TV is connected to the TV SCART socket. If needed, manually select the SCART input directly on your TV.
Why is there black and white video on VCR output during VCR/DVD recording with my SAGEMCOM DVR?
If you're seeing black and white video on the VCR output while recording with your SAGEMCOM DVR, check that the signal type selected for VCR Scart output is compatible with your VCR.
Why does a black screen (no video) appear at the end of a recording on my SAGEMCOM DVR?
A black screen may appear at the end of a recording on your SAGEMCOM DVR if the program ends on a broadcast that does not transmit a recordable video signal. In such cases, the video recording stops, but the time counter continues until the scheduled recording time ends.
What to do if I have any other problem with my SAGEMCOM DVR?
To resolve any other problem with your SAGEMCOM DVR, perform a default factory reset.
General| Type | DVR |
|---|---|
| Brand | SAGEMCOM |
| Model | RCI88-320 |
| Hard Drive Capacity | 320 GB |
| Network Interface | Ethernet |
| Remote Viewing | Yes |
To Next Page
