Internet Radio RM50 Quick Start Guide
- 5 -
Turning On The Device for The First Time
Network Environment
Please confirm that your wireless router or Access Point (AP) is connected to the
broadband network. The diagram below describes the network
environment that should be established to use your IP Radio.
Setting Up The device
(1) Plug the included power adapter into a wall outlet.
(2) Connect the power adapter to the power jack on the rear panel of the device.
(3) Press and hold the Power button on the rear panel to turn on the device.
After the device is turned on, a welcome screen appears.
Note: Turning on the device for the first time will require you to set up the
Network, Language and Time Zone for your device. Please follow the
setup guide for proper setup.
The device will scan for network connection automatically.
After A Network Is Found
After scanning and a network connection is found, a Scan for networks menu
displays:
Rotate the Wheel to select the desired network connection method.
QG RM50 Print.fm Page 5 Lundi, 19. avril 2010 9:30 09
To Next Page
Loading...
Need help?
General