SAHP BMTB 130 - SECTION 11 REPLACEMENT OF PARTS

32| SAHP - BMTB Installation Manual
V1 Mar 2019US - SD667052
10.1 For quality and consistency of performance it is
recommended that only Manufacturers supplied and approved
parts be used for initial installation and replacement.
 Noguaranteeofperformancecanbegivenifnon
Manufacturer approved parts are used.
!
REPLACEMENT
OF PARTS








240V 1.5 Kw immersion heater 1 3/4” thread
Unvented cold feed combination control set
Secondary expansion vessel
Mounting bracket
Pressure and temperature relief valve
Control and high limit thermostat
Hot water multi port zone valve
Tundish
   
   
SECTION 11