SAHP BMTB 130 - Page 39

SAHP - BMTB Installation Manual |39
V1 Mar 2019US - SD667052
SECTION 12
GUARANTEE TERMS
AND CONDITIONS continued
The Guarantee shall be subject to the following conditions:
Its installation shall be carried out in accordance with the manufacturer’s
instructions and in compliance with all the technical and safety standards
applicable whether they are European, national or autonomous; it shall also
be undertaken by qualied staff.
The Guarantee shall be null and void if any of the following takes
place:
• Incorrect equipment is used for installation.
• The equipment has been installed by staff other than an F Gas qualied
engineer.
• The equipment has been used for purposes other than those described in
the use and deployment standards or in some way other than that
recommended in the mentioned standards.
• The usage and maintenance instructions have not been complied with.
• Water supply for the unit that meets some of the following criteria:
Chlorides content > 200mg/L, pH value<6 (scale Sorensen a 25ºC),
Sulphate content > 2000mg/L, Chloride and sulphate content > 300mg/L,
CaCO3 content >300ppm. In general water with values exceeding ceilings
set by legislation.
• Absence of security group in the inlet system according to the legislation.
• System malfunction arising from improper installation of the hydraulic circuit
components and/or buffer tank.
• Installation of elements outside the specications of the installation manual.
• Damage resulting from improper anchoring equipment.
• Unit malfunction due to lack of thermal insulation in the installation
• Incorrect placement of thermodynamic solar panel or box
• The equipment has received an overload of any nature: electrical, water
pressure etc.
• Malfunctions brought about by chance or force majored: atmospheric,
geological phenomena etc.
• The equipment has not been delivered in its original box.
• Damage from atmospheric and external agents: Freezing, dirt, transport,
or accidental impacts.
• Damages derived from an unusual supply of electricity, water or air
(included over pressure and over voltage).
• Damage caused by daily wear in metal or plastic.
• Breakdowns caused by the replacement of parts or elements not original or
authorized in writing by the manufacturer.
• Damages caused by the unusual corrosion of the heat exchanger and/or
the hydraulic circuit caused from reaction with the circulating uid.
• Damages caused from the installation itself.
• Damaged caused by vandalism acts, war, re, etc.
!