1
The RC Laser
was designed to be a st rict “one-design” sailboat. The fundamental principle
behind a one-design sailboat is tha t sailors may not alter their boats. This
ensures t hat racing is a competition among sailors, no t boats. If you intend to
race your RC Laser, you may not change your boat in any other way other
than to decorate it as explained in this manual. All re placement parts must be
genuine RC Laser parts. The only exceptions are the transmitter and
receiver, which may be replaced with any compatible equipment.
Your RC Laser has the following components:
Sail and tell tale Mast
Rudder Rudder bracket
Gooseneck Rudder linkages (2)
Rudder servo Boom
Boom sliders (3) Antenna mount
Antenna tube Sheet line
Screw eye Sail control servo
Hull Tran smitter
Receiver Hatch cover
Battery holder Switch
Manual
If you need to purchase replacement parts, you can contact the retailer
where you purchased your RC Laser, or your local distributor. A list of RC
Laser distributors can be found in the back of this manual.
To Next Page
Loading...