SailRC RC Laser - Racing and Boat Components; Common RC Laser Race Courses; Keel Installation Procedure; Rudder Installation Procedure

20
5
2 KEEL
RACING YOUR RC LASER
There is an infin ite numb er of possible race courses you ca n
sail - the only limit is your imagination. Here are two of th e more
commonly used courses to get you started.
Modified Olympic Course
wind direction
Jockey for the best position
d u r i n g a o n e m i n u t e
countdown. Sail two laps
ar oun d t he c our se, n ot
rounding the wing buoy on
the second lap.
Wing buoy
Start/finish line
Pivot hole
Rotate locking lever 90 degrees
until lever locks in place.
Insert rudder stud into pivot
hole on bottom of hull while
inserting top of rudder into
rudder deck bracket. Snap
rudder into bracket.
3 RUDDER
NOTE:
If the surface of the keel bulb becomes damaged, exposing
the lead core, cover it with tape or paint. Keep away from
exposed lead.