SailRC RC Laser - Sail and Mast Assembly; Connecting Mast Sections; Attaching Sail and Boom to Mast

4
21
Lap 1
1 SAIL AND MAST
Here’s a cou rse that offers a
lot of opportunities to make
ch o ice s a nd th i nk ab out
strategy, because there are a
number of different paths
you can take on each lap.
Sail thro u gh the sta r t i ng
g a t e , th e n r o u n d t h e
windward buoy and offset
windward buoy. Travel down
to the leeward gate and pass
around it in any direction.
S a i l b a c k t o wa r d s t h e
windward buoy and do one
m o r e l a p , r o u n d in g t h e
windward and then t he offset
b u o y o n c e a g a i n . A f t e r
rounding the leeward gate
one more time , f i n ish by
co m ing b ack t h rough the
starting gate.
Lap 2 and finish
START
Windward buoy
Starting gate
Leeward gate
Offset buoy
START
Windward buoy
Starting gate
Leeward gate
Offset buoy
wind direction
A) Connect mast tubes.
C) Slide boom into gooseneck.
D) Thread outhaul string, attached to the sail,
through the end slider and snap into the next
slider forward (see page 7 for diagram)
B) Insert assembled mast into sail pocket.