Instruments and controls 1-9
4-wheel drive indicator
light
This light comes on when the
transfer shift control switch is in
the “4H” or “4L” position.
For the ELEC. Transfer vehicles,
when the switch is in the “4H”
position, green indicator light
comes on; when the switch is in
“4L” position, yellow indicator
light comes on (For more details,
see Character 4). If the light
remains on when shifting from
“4H” to “2H”, the 2-wheel drive is
not selected.
Ensure safety and either
accelerate, decelerate or back
up the vehicle to change to
2-wheel drive.
Seat belt warning lights
Warning light is used to remind
you to fasten your seat belt.
Whenever the ignition key is
located in the "ON",the Light will
being on until the driver wearing
a seat belt.
Alarm lamp door open
Warning light is used to remind
you to close the door, when the
vehicle starts, any door is not
closed, the alarm lamp lights up.
Engine fault alarm lamp
When the engine running, the
light turns up saying there is
potential problem of engine
control. At this point, although
cars can continue to drive, also
please going to the zhengzhou
nissan service network
maintenance as soon as
possible. Don't let your car was
towed to the depot for failure. If
not check and repair the engine
control problem, continuing to
drive will lead to bad
performance, reduce fuel
economy, and cause damage to
the engine control system.
Overspeed alarm lamp
This lamp is used to remind
users of not overspeeding more
than the current system setting
speed limit (120 km/h), when the
speed is greater than this value,
the alarm lamp lights up, when
the speed is less than 118 km/h,
alarm lights went out.
To Next Page
Loading...
