4-001
PARTS CATALOGUE
1. GUIDE FOR USE OF PARTS CATALOGUE
1. Quote the following when placing an order for parts.
(1) Vehicle model
(2) Chassis number
(3) Part number
(4) Part name
(5) Quantity of required parts.
The vehicle model and chassis number are engraved on the identification plate, and chassis number is also
punched on the frame.
2. The chassis number to which parts are applicable are described in the remarks column as follows.
-No.10007 : Applicable up to 10007
No.10008- : Applicable from 10008
3. Each quantity shown in the quantity column is in principle one applied to a unit of vehicle.
However, each quantity as related to ASSEMBLY PARTS indicates one included in a single unit of assembly.
4. The following abbreviated words are used in this parts catalogue.
LH : Lefthand viewed from behind of vehicle.
RH : Righthand viewed from behind of vehicle.
Inc.
○
-
○
: Key number of parts constituting an assembly
OP : Option
N/S : Parts not to be supplied by a single piece
A/S : Parts to be supplied as an assembly composed or a kit of parts
AR : As required
Dom. : For use in Japan
Exp. : For use in countries other than Japan
*SEE PAGE
○○
: See page
○○
for component parts.
5. Part with “(cf.
○
)” in the remarks column indicates that it is supplied as an assembly represented by the key
number
○
with which “cf.” is attached. Quote the part number that follows the key number
○
when ordering.
6. Part number with a mark “*” indicate that they have been corrected to the ones listed just below them. Quote the
renewed part numbers when ordering.
7. Parts are subject to change without notice.
Chassis number
Model PC800 VPC23-00000
Chassis number
To Next Page
Loading...
