变频器运行后 电机不转
动
Motor not running after
frequency converter
running
电机线没接好；Not connect motor wire well;
变频器参数设置错误（电机参数）； Error
frequency converter parameter setting (motor
parameter);
驱动板与控制板连线接触不良；Bad contact
between drive board and control board wire;
驱动板故障；Drive board failure;
重新确认变频器与电机之间连 线；
Confirm the wire between frequency
converter and motor;
更换电机或清除机械故障； Renewal
motor or solve the mechanical failure;
检查并重新设置电机参数；
Check and
reset motor parameters;
变频器频繁报 过流和过
压 故 障
Frequency
converter frequently
report over current and
over voltage failure
电机参数设置不对； Incorrect motor
parameter setting;
加减速时间不合适； Unsuitable accelerate
and moderate time;
负载波动；Load wave;
重新设置电机参数或者进行电 机调
谐；
Reset motor parameter or process
motor tune;
设置合适的加减速时间；Set suitable
accelerate and moderate time;
寻求厂家服务；Seeking factory service
控制板上相关器件坏；The relate apparatus
on control board damaged;
更换控制板；
Renewal control board;
To Previous Page
Loading...
