What to do if my Sako SKI600 Inverter shows E-03 error?
If your Sako Inverter displays the E-03 error, first check the power supply due to a possible low network voltage. Also, examine the load for sudden changes or abnormalities, and reduce the change of the load if needed. If the driver's power is too low, select a driver with a larger capacity.
What should I do if Sako SKI600 Inverter displays E-04 error?
If your Sako Inverter shows an E-04 error, check the power supply because of a possible abnormal supply voltage. If the driver is restarted with a rotating motor, start after setting it to DC braking, or use rotational speed tracking start. For special potential energy loads, connect a suitable braking resistor or braking unit.
What to do if Sako SKI600 Inverter displays E-05 error?
If your Sako Inverter is showing E-05, prolong the Dec time. If the load inertia is too high, connect a suitable braking resistor or braking unit. Also, check the power supply for any abnormalities.
To Next Page
General
