Sako SKI600 - Function Parameter Table and Description; Monitoring Parameter Group and Fault Record

025
4.0 Monitoring Parameter Group and Fault Record
4 Function Parameter Table and Description
D Group - Monitoring Parameter Group and Fault Record
Function
Code
Name Set Range
Minimum
Unit
Factory
Default
Modi󽗉cation
d-00
Output
Frequency
0.00 ～ maximum output frequency
【F0.15】
0.01Hz 0.00 ◆
d-01 Set Frequency
0.00 ～ maximum output frequency
【F0.15】
0.01Hz 0.00 ◆
d-02
Estimated Motor
Frequency
0.00 ～ maximum output frequency
【F0.15】
Note: motor running frequency
converted from estimated motor speed
0.01Hz 0.00 ◆
d-03
Main Set
Frequency
0.00 ～ maximum output frequency
【F0.15】
0.01Hz 0.00 ◆
d-04
Auxiliary Set
Frequency
0.00 ～ maximum output frequency
【F0.15】
0.01Hz 0.00 ◆
d-05 Output Current 0.0 ～ 6553.5A 0.1A 0.0 ◆
d-06 Output Voltage 0 ～ 999V 1V 0 ◆
d-07 Output Torque -200.0 ～ +200.0% 0.1% 0.0% ◆
d-08
Motor Revolving
Speed (RPM/min)
0 ～ 36000（RPM/min） 1 0 ◆
d-09
Motor Power
Factor
0.00 ～ 1.00 0.01 0.00 ◆
d-10
Run Linear
Velocity (m/s)
0.01 ～ 655.35(m/s) 0.01 m/s 0.00 ◆
d-11
Set Linear
Velocity (m/s)
0.01 ～ 655.35(m/s) 0.01 m/s 0.00 ◆
d-12 Bus voltage (V) 0 ～ 999V 1V 0 ◆
d-13 Input Voltage (V) 0 ～ 999V 1V 0 ◆
d-14 PID Set Value (V) 0.00 ～ 10.00V 0.01V 0.00 ◆
○—modi󽗉able parameter under any candition ×—nat modi󽗉able parameter under run status
◆—the actual detected parameter, not modi󽗉able ◇—factory parameter, only modi󽗉able for
factory, not allowed for users modifying