Sako SKI600 - Communication Address of All Parameters

159
5.9 Communication Address of all Parameters:
Notice:
◇ In the above examples, the driver address is 01, which makes it better for illustration; when
the driver is slave, the address setting range is 1 ～ 247, and if any data of frame format is
changed, the check code needs to be recalculated. The calculating tools of 16bit CRC check
code can be download from internet.
◇ Initial address of monitor item is D000, each item offset corresponding hexadecimal value
based on this address, then plus it with the initial address. For example: the monitor initial
item is d-00, the corresponding initial address is D000H (1D00H), now read monitor item
d-18, 18-00=18, the corresponding hexadecimal of 18 is 12H, then the read address of d-18 is
D000H+12H = D012H (1D00H+12H = 1D12H). Address D000H and 1D00H are interchangeable.
◇ Frame format when the slave response information is abnormal: driver address +
(80H+function code) + 16bit CRC check code; if the salve return frame is 01H + 83H + 04H +
40F3H, then 01H is slave address, 83H is 80H+03H indicating read error, 04H is invalid data
length, 40F3H is 16bit CRC check code.
Function code Communication address
F0.00 ～ F0.22 0000H ～ 0016H
F1.00 ～ F1.37 0100H ～ 0125H
F2.00 ～ F2.17 0200H ～ 0211H
F3.00 ～ F3.08 0300H ～ 0308H
F4.00 ～ F4.27 0400H ～ 041BH
F5.00 ～ F5.24 0500H ～ 0518H
F6.00 ～ F6.52 0600H ～ 0634H
F7.00 ～ F7.36 0700H ～ 0724H
F8.00 ～ F8.33 0800H ～ 0821H
F9.00 ～ F9.73 0900H ～ 0949H
FA.00 ～ FA.35 0A00H ～ 0A23H
FB.00 ～ FB.07 0B00H ～ 0B07H
FC.00 ～ FC.28 0C00H ～ 0C1CH
FE.00 ～ FE.15 0E00H ～ 0E0FH
FF.00 ～ FF.22 0F00H ～ 0F16H
d-00 ～ d-57 D000H（1D00H）～ D039H（1D39H）
Communication Protocol