❑ Transport should be done by qualified and specifically trained personnel,
❑ Grab the mower by any lifting devices only in places indicated by hook sign (Fig. 4),
❑ For mower lifting, use only lifting devices with hoisting capacity larger than mower’s weight shown
in data plate. This also applies to ropes and chains used for lifting,
❑ Do not lift if transport belts, belt suspensions, ropes are damaged. Whenever damage to these
parts occurs, replace with new ones,
❑ When mounting slings, chains, handles etc., always set the machine's center of gravity properly,
❑ To safely support the machine, use ropes of adequate length so that the angle between them is no
greater than 120°, and the angle between the strand and the vertical is no greater than 60°,
❑ Lift the machine with the utmost caution and move it slowly,
❑ No one should be within the range of action of the lifting equipment when any transporting
operations are being carried out,
❑ Collapsible parts should be blocked in transport position,
❑ When the mower is on the vehicle’s trailer, the machine should be secured against moving.
Fig. 4. Transport holders
NOTICE:
Securing both the danger area and activity performed shall lie under the responsibility
of the person in charge of the mower transporting.
To Next Page
Loading...
Need help?
General
