Samlexpower EVO-RC-PLUS - Page 30

30 | SAMLEX AMERICA INC.
SECTION 4 | Parameter Setup
4.1.3 "Select Parameter" Menu Map
When any of the 7 Parameter Groups from the "Select Group" Menu Map (Fig 4.1) is selected, access is available to
the "Select Parameter" Menu Map pertaining to that Group. Location of "Select Parameter" Menu Maps are given in
Table 4.2.
Table 4.2 Locations of "Select Parameter" Menu Maps
"Select Group"
Menu Map (Fig 4.1)
Column (1)
Location of "Select
Parameter" Menu Map
Column (2)
Location of TABLES
for Parameter details
Column (3)
Group 1 - CHARGE CURVE Fig 4.2
Table 4.3 (Section 4.4)
Group 2 - INPUT SETTING Fig 4.3
Table 4.4 (Section 4.5)
Group 3 - INPUT LOW LIMIT Fig 4.3
Table 4.5 (Section 4.6)
Group 4 - INPUT HIGH LIMIT Fig 4.3
Table 4.6 (Section 4.7)
Group 5 - OTHER FUNCTION Fig 4.4
Table 4.7 (Section 4.8)
Group 6 - TIME SETTING Fig 4.5
Section 4.9
Group 7 - STOP SD CARD Fig 4.5
Section 4.10
NOTE: Figs 4.2 to 4.4 show the default/factory preset parameters for EVO-1212F / 1212F-HW. For parameters for other
Models, refer to Tables shown under Column (3) of Table 4.2.
For explanation of the format of the "Select Parameter" screen, refer to Fig 4.2, Screen
No. 1 - "Select Parameter" - BULK CURRENT (extract given below):
S e l e c t P a r a m e t e r
C H A R G E C U R V E
* B U L K C U R R E N T
2 0 A
Screen
No. 1
NOTE: The information in
this screen pertains to
Model No. EVO-1212F
• The 2nd line shows the Parameter Group - CHARGE CURVE in this case
• The 3rd line - "BULK CURRENT" in this case shows that this parameter is earmarked for programming.
The asterisk * against this line shows that this parameter will be accessed for programming when Enter
key is pressed.
• The 4th line shows the default/factory preset value for BULK CURRENT (20A for EVO-1212F / 1212F-HW).
• Refer to Tables shown in Column 3 of TABLE 4.2 above for parameter details for various models.