34 | SAMLEX AMERICA INC.
4.1.3.4 "Select Parameter" Menu Maps for (i) Parameter Group 6: TIME SETTING and
(ii) Parameter Group 7: STOP SD CARD
S e l e c t P a r a m e t e r
T I M E S E T T I N G
* E n t e r t h e t i m e
2 0 0 0 / 0 1 / 0 1 0 0 : 0 0
S e l e c t P a r a m e t e r
S T O P S D C A R D
0 = N o
NOTE:
Value shown in the 4th line of the display screen is the default / factory pre-set value. For additional programming
details, refer to (i) Section 4.9 for “TIME SETTING” and (ii) Section 4.10 for STOP SD CARD”
Group 6
"TIME SETTING"
Group 7
"STOP SD CARD"
Fig 4.5 "Select Parameter" Menu Map for (i) Parameter Group 6:
TIME SETTING and (ii) Parameter Group 7: STOP SD CARD.
4.2 PARAMETER SETUP PROCEDURE
4.2.1 General Information - Parameter Setup Procedure
Please refer to Fig 4.6.
The Enter key is used to enter "Select Group" Menu Map from any Operating Mode Screen shown in Figs 3.1 to 3.5.
Example in Fig 4.6 starts with Inverting Mode Screen [Screen 1 in Figs 3.2(a) and 3.2(b)]. After the Enter key is pressed,
the Up/Down keys are used to navigate to one of the 7 "Select Group" Screens (Fig 4.1). When the Group for the
desired setting is displayed on the LCD, the Enter Key is used again to select this Group. The Up and Down Keys are
used to move to the individual screens within the Group.
Pressing the Back Key will exit to the previous level.
INFO
There is a 30 second timeout for setting parameters; after 30 seconds the Setting Mode will be cancelled and
the display will revert to the Operating Mode Screen associated with current operation.
It is highly recommended to set the EVO™ Date and Time (Parameter Group 6, Screen No. 6 in Fig 4.1) as this value is
used to record data logging les. (Refer to Section 4.9 for Date and Time set up).
SECTION 4 | Parameter Setup
To Next Page
Loading...