Samson 3244-1 - Page 14

2-2 EB 8026 EN
Markings on the device
Item Inscription meaning
17 Cage/seat style:
CS:clamped-in seat · CG:guided cage ·
SS:screwed-in seat · SF:suspended cage,
anged seat
18 Country of origin
19 ID of the notied body (EU), for example:
− 0062 for Bureau Veritas Services SAS,
8Cours du Triangle, 92800 PUTEAUX –
LA DEFENSE
21 PED: Pressure Equipment Directive
G1/G2: gases and vapors
Fluid group1= hazardous
Fluid group2= other
L1/L2: liquids
Fluid group1= hazardous
Fluid group2= other
I/II/III: Category 1 to 3
22 Serial number
23 Hardware version (NE53)
We recommend to include the device's serial
number (22 on the nameplate) and/or its
material number (as specied in the order
conrmation) in the plant documentation for
the associated tag number.
The serial number enables you to view the
device's current technical data as congured
by SAMSON. The material number enables
you to view the device's technical data as
congured by SAMSON upon delivery of
the device. To view these data, go to our
website at uwww.samsongroup.com >
Products > Electronic nameplate.
For example, you can also use the associat-
ed information to order a new nameplate
from our After-sales Service, if required.
2.2 Actuator nameplate
See associated actuator documentation.
2.3 Material identication
number
The seat and plug of the valves have an item
number written on them. You can contact us
stating this item number to nd out which
material is used. Additionally, a seat code is
used to identify the trim material. This seat
code is specied on the nameplate.
Tip