Samson 3321 - Page 37

EB 8111/8112 EN 37
Servicing
Risk of valve damage due to excessively high
or low tightening torques.
Observe the specied torques on tightening
control valve components. Excessively tight-
ened torques lead to parts wearing out
quicker. Parts that are too loose may cause
leakage.
Observe the specied tightening torques
(uAB0100).
Risk of valve damage due to the use of un-
suitable tools.
Only use tools approved by SAMSON
(uAB0100).
Risk of valve damage due to the use of un-
suitable lubricants.
Only use lubricants approved by SAMSON
(uAB0100).
The control valve was checked by SAMSON
before it left the factory.
− Certain test results (seat leakage and leak
test) certied by SAMSON lose their
validity when the valve body or actuator
housing is opened.
− The product warranty becomes void if ser-
vicing or repair work not described in
these instructions is performed without pri-
or agreement by SAMSON's After-sales
Service department.
− Only use original spare parts by
SAMSON, which comply with the original
specications.
The procedure to remove or mount the actu-
ator for service work depends on the type of
attachment (FormB or FormC, see sec-
tion3.2).
NOTICE
!
NOTICE
!
NOTICE
!
Note
Note