Quick Start
Run an audio signal (such as music from a CD) from your mixer, and check that you
are getting good levels using the mixer's output meter.
Slowly raise the satellite speaker(s) level control until
you have reached a comfortable level. Then raise the
Auro D1200 Level control until you have reached a
level that sits well within the rest of the mix.
If the volume from the D1200 gets too loud, or you notice the LIMITER indicator
blinking frequently, turn down the Level control on the Auro D1200 a little until the
LIMITER indicator does not light, or only lights occasionally with signal peaks.
10
To Next Page
Loading...
