11
Expedition Pro XP300
17: Limiter switch - Use this switch to turn the built-in limiter circuitry on or off. In order
to maximize speaker protection, we recommend that this switch be left in the “on” position
during normal operation.
18: Voltage selector - Make sure this is set correctly for the country you are in before turning
on the power to the XP300.
19: Gain switch - Sets the line-level TRS input of channel 3/4 (see #6 on the preceding
page) to either +4 (professional) or -10 (consumer) level.
20: Power switch - Use this to turn power to the XP300 on or off. If an optional RB 2030
rechargable battery pack is installed, it will charge when this switch is in the “Off” position.
Interconnecting the XP300
Using one XP300: In this example, microphones are connected to the XLR mic inputs of chan-
nels 1 and 2, and a stereo keyboard is connected to the stereo 1/4" TRS connector of channel
3/4 (using a Y-cord, with the tip carrying the left signal and the ring carrying the right signal).
IMPORTANT NOTE: When using just one XP300, always be sure to set its Mono/Stereo
switch to “Mono.”
ENGLISH
11
To Next Page
Loading...
