3 Disassembly and Reassembly
3-2 GH19B*
CONFIDENTIAL
4. Put the jig into the gap (between the right side
of the panel the and Front Cover) and tilt up
Front Cover until the snap opens.
5. Put the jig into the gap (between the right side
of the panel the and Front Cover) and tilt up
Front Cover until the snap opens.
6. After pushing the right bottom of the panel
with jig.
7. Pull up the Rear Cover until it opens fully.
3-2 Reassembly
Reassembly procedures are in the reverse order of Disassembly procedures.
To Next Page
Loading...
