Samsung 214T

10 Operating Instructions and Installation
10-2
POWER S/W
: Switch the monitor on and off.
POWER IN
: Power cord, plugs into monitor and wall receptacle.
10-2 Rear
4) Custom Select this mode when you want to
adjust the image according to your preferences.
3. Brightness button [ ]
- When OSD is not on the screen, push the button
to adjust brightness.
4. Enter button [ ] / SOURCE button
- Activates a highlighted menu item. /
Push the 'SOURCE', then selects the video signal
while the OSD is off. (When the source button is
pressed to change the input mode, a message
appears in the upper left of the screen displaying
the current mode -- Analog, Digital, Video and S-
Video input signal.)
Note : Changing the source is allowed only in
external devices that are connected to the monitor
at the time.
5. AUTO button
(Available in analog mode only)
- When the 'AUTO' button is pressed, the Auto
Adjustment screen appears as shown in the
animated screen on the center.
Auto adjustment allows the monitor to self-adjust
to the incoming video signal. The values of fine,
coarse and position are adjusted automatically.
6. PIP button
( Available in Analog/Digital(PC) Mode Only )
- In Analog or Digital Mode, turns on Video
screens in PIP Mode.
7. Power button
- Use this button for turn the monitor on and off.
8. Power Indicator
- This will enable you to see the overall power
status of the system.