You can control your set-top-box
or
satellite
box
with the Remote Control.
To
establish
control, you must first set
up
the
IR
extender cable. If you
don't
have an STB, skip this
section.
1 Connect the
IR
extender cable
to
the
TV's
IR
output connector.
~a
1'-<!>J..:
. .t I
I
I
Place the transmitter
end within 4 inches
of
the set-top-box's
remote control sensor.
2 Position the transmitter end within 4 inches
(1
0 em)
of
the set-top-box's remote
control sensor, pointing
in
the direction
of
the sensor. Make sure there are
no
obstacles between the transmitter end
of
theIR
extender cable and the set-
top-box
or
satellite box. Any obstacles will interfere with the transmission
of
the
remote control signals.
3 Finalize control
of
your set-top
or
satellite
box
when you run Initial Setup.
To Next Page
Loading...
