Samsung 630 series User Manual (English)

Questions and Answers:

D
donovannicholasJul 30, 2025
Why is Anynet+ not working on my Samsung 630?
- J
  Joseph RoyJul 30, 2025
  If Anynet+ is not working, ensure the device is Anynet+ compatible, as the system supports only Anynet+ devices. Connect only one receiver (home theater). Verify that the Anynet+ device's power cord and Video/Audio/HDMI 1.3 cable connections are properly connected. Also, check that Anynet+ (HDMI-CEC) is set to 'On' in the Anynet+ setup menu and that the TV remote control is in TV mode. Anynet+ may not function during certain operations like searching channels or using Media Play. If you connect or disconnect the HDMI 1.3 cable, search for devices again or power cycle your TV. Finally, make sure the Anynet+ function on the Anynet+ device is enabled.
K
Kristen ShawAug 3, 2025
What to do if connected device is not displayed on Samsung 630 LCD TV?
- A
  Andrew PaulAug 3, 2025
  If the connected device is not displayed, verify that the device supports Anynet+ functions and that the HDMI 1.3 cable is properly connected. Ensure that Anynet+ (HDMI-CEC) is set to 'On' in the Anynet+ setup menu. Try scanning for Anynet+ devices again. Note that only HDMI 1.3 cables support Anynet+ and some HDMI cables might not support it. If the connection was interrupted by an issue such as disconnecting the HDMI cable or a power failure, repeat the device scan.
A
adrienneloweAug 7, 2025
How to start Anynet+ on Samsung LCD TV?
- S
  Sarah LucasAug 7, 2025
  To start Anynet+, check that the Anynet+ device is properly connected to the TV and that Anynet+ (HDMI-CEC) is set to 'On' in the Anynet+ Setup menu. Switch to TV mode by pressing the TV button on the TV remote. Then, press the TOOLS button to display the Anynet+ menu and select the desired option.
M
Michael GriffinAug 12, 2025
How to exit Anynet+ on Samsung 630?
- E
  elizabeth31Aug 12, 2025
  To exit Anynet+, select 'View TV' in the Anynet+ menu. Alternatively, press the SOURCE button on the TV remote and select a device other than an Anynet+ device. You can also press z, CH LIST, PRE-CH, and FAV.CH to change the TV mode. Note that the channel button operates only when a tuner-embedded Anynet+ device is not connected.
M
megan83Aug 16, 2025
How to output TV sound through receiver on Samsung 630?
- A
  Amanda JonesAug 16, 2025
  To output TV sound through the receiver, connect the optical cable between the TV and the receiver.
M
Mary StewartAug 20, 2025
What to do if message 'Connecting to Anynet+ device...' appears on Samsung LCD TV?
- J
  Julie MoralesAug 20, 2025
  When the message 'Connecting to Anynet+ device...' appears, you cannot use the remote control while Anynet+ is being configured or while switching to a view mode. Use the remote control once the Anynet+ setting or switching to view mode is complete.
L
Lori RobertsAug 25, 2025
Why Anynet+ device does not play on Samsung 630?
- T
  Troy VazquezAug 25, 2025
  The play function is unavailable when Plug & Play is in progress.