47
Installation
Setting the indoor unit option code with wired remote controller
In order to set the indoor unit option code use the wired remote controller and follow the directions below.
Away/MDS
Main Menu
Sub-menu
1 2 3 54 6
Data bit
1 234 56
Option CodePage number
SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
0
Page number
SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
1
Page number
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18
2
Page number
SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
3
Page number
Press the
and buttons at the same time for more than 3 seconds and then a Main menu will be displayed.
1. Press the / button to select and then press button to enter a Sub-menu setting screen.
2. Press the
/
button to select and then press button to enter a Indoor unit option code setting screen.
NOTE
3. Press the
/
button to set the option code in order. Press button to go to the next page.
4. Press the
button to save and complete the option setting.
5. Press the
button to exit to normal mode.
NOTE
Press the button anytime during setup to exit without setting.
Installation Procedure
DB68-11271A-02_IM_CAC Universal AHU Indoor_AA_EN_.indd 47 2022-09-15 오전 9:53:31
To Next Page
Loading...
