Samsung AC RN DKG Series - Setting Installation Options in Batch

29
Installation Procedure
English
Setting the installation options in a batch
Option No. for an indoor unit address: 02XXXX-1XXXXX-2XXXXX-3XXXXX
1 Make sure that the power is supplied to the
indoor unit. If the indoor unit is not plugged in,
it must include a power supply.
F1
1(L)
2(N)
F2
V1
V2
F3
F4
Indoor Unit
2 Set the installation options of indoor units, by referring to the following table and by following the steps in
Common steps for setting the addresses and options on page 22.
ŷ The installation options of indoor units are set to 020000-100000-200000-300000 by default.
ŷ The SEG20 option, Individual control with remote control, allows you to control multiple indoor units
individually by using the remote control.
Option SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
Function Page Mode
Reserved
Use of external
temperature
sensor
Use of central
control
Compensation of
the fan RPM
Indication
and details
Indication Details Indication Details Indication Details Indication Details
Indication
Details
02
0 Disuse 0 Disuse
0
Disuse
(recessed
installation)
1 Use 1 Use 1
RPM
compensation
Option SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
Function Page Use of drain pump
Reserved Reserved Reserved
Dew removal
operation in
Wind-free mode
Indication
and details
Indication Details Indication Details
Indication
Details
1
0
Disuse
0
Maintain
blade status
in Wind-
Free mode
1 Use
2
Use with 3
minute delay
1
(Default)
Cooling
operation by
opening the
blade