Samsung AC RNCDKG Series - Page 18

18
Installation Procedure
English
Installation Procedure
1 Enter the mode for setting the options:
a Remove the batteries from the remote control,
and then insert them again.
b While holding down the (High Temp) and
(Low Temp) buttons simultaneously, insert the
batteries into the remote control.
c Make sure that you are entered to the mode for
setting the options:
2 Set the option values.
CAUTION
• The total number of available options are 24: SEG1 to
SEG24.
• Because SEG1, SEG7, SEG13, and SEG19 are the page
options used by the previous remote control models,
the modes to set values for these options are skipped
automatically.
• Set a 2-digit value for each option pair in the
following order: SEG2 and SEG3 → SEG4 and SEG5
→ SEG6 and SEG8 → SEG9 and SEG10 → SEG11 and
SEG12 → SEG14 and SEG15 → SEG16 and SEG17 →
SEG18 and SEG20 → SEG21 and SEG22 → SEG23 and
SEG24
SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
0 X X X X X
SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
1 X X X X X
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18
2 X X X X X
SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
3 X X X X X
On (SEG1 to SEG12) Off (SEG13 to SEG24)
Take the steps presented in the following table:
Option setting Status
1 Setting SEG2, SEG3 option
Press Low Fan button
to enter SEG2 value.
Press High Fan button to enter SEG3 value.
Each time you press the button, will be selected in
rotation.
SEG2 SEG3
2 Setting Cool mode
Press Mode button to be changed to Cool mode in the ON status.
3 Setting SEG4, SEG5 option
Press Low Fan button
to enter SEG4 value.
Press High Fan button to enter SEG5 value.
Each time you press the button,
will be selected in
rotation.
SEG4 SEG5