13
ENGLISH
Outdoor unit installation
The outdoor unit must be installed on a rigid and stable base to avoid increased noise levels and vibration. If the outdoor unit
is to be installed in a location exposed to strong winds or high above the ground, the unit must be xed to an appropriate
support (wall or ground).
Fix the outdoor unit with anchor bolts.
• The anchor bolt must be 0.79 inch or higher from the base surface.
NOTE
(Unit : inch)
Anchor bolt hole
13.0
14.2
15.1
24.4
37.0
• Make a drain outlet around the base for outdoor unit drainage.
• If the outdoor unit is installed on the roof, you have to check the ceiling strength and waterproof the unit.
CAUTION
Location of the compressor
• Make sure that product is level during installation. Especially, product shouldn’t be tilted towards the
compressor.
CAUTION
To Next Page
Loading...
