Samsung AC026HBLDKH - How to Connect Your Extended Power Cables

32
1. Prepare a compressor and the following tools.
Tools Crimping pliers Connection sleeve (mm) Insulation tape Contraction tube (mm)
Spec MH-14 20xØ6.5(HxOD) Width 19mm 70xØ8.0(LxOD)
Shape
2. As shown in the gure, peel o the shields from the rubber or wire of the
power cable.
- Peel o 20 mm of the wire shields of the tube installed already.
• After peeling o the tube wire, you must insert a contraction tube.
• For information about the power cable specications for indoor and
outdoor units, refer to the installation manual.
CAUTION
(Unit: mm)
120
60
202020
180
Power cable (provided by us)
20
Wire tube power cable
3. Insert both sides of core wire of the power cable into the connection sleeve.
 Method 1
Push the core wire into the sleeve from both sides.
Connection sleeve
 Method 2
Twist the wire cores together and push it into the sleeve.
Connection sleeve
4. Using a compressor, compress the two points and ip it over and compress another two points in the same location.
- The compression dimension should be 8.0.
- After compressing it, pull both sides of the wire to make sure it is rmly pressed.
Compression
dimension
 Method 1
Compress it 4 times.
5 mm
 Method 2
Compress it 4 times.
5 mm
How to connect your extended power cables