Samsung AC071MN4PKH - Page 30

30
Installation Procedure
Installation Procedure
English
Setting the indoor unit addresses
Option No. for an indoor unit address:
0AXXXX-1XXXXX-2XXXXX-3XXXXX
Before installing an indoor unit, be sure to set an address
for the indoor unit by taking the following steps:
1 Make sure that the power is supplied to the indoor
unit. If the indoor unit is not plugged in, it must
include a power supply.
Indoor unit
F1 F2
LN
2 Set an address for each indoor unit using the remote
control, according to your air conditioning system
plan, by referring to the following table and by
following the steps in Common steps for setting the
addresses and options on page 19.
ŷ The indoor unit addresses (main and RMC
addresses) are set to 0A0000-100000-200000-
300000 by default.
ŷ If indoor units and outdoor units match 1:1, you
don’t need to set the main address because it is
automatically set by the outdoor unit.
ŷ If you are using on or off controller, set RMC
address.
Option SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
Function Page Mode
Setting main
address
Reserved
Indoor unit number Indoor unit number
Indication
and details
Indication Details Indication Details Indication Details Indication Details Indication Details
0A
0
No main
address
0 to 1
Tens
digit
0 to 9
Units
digit
1
Main
address
setting
mode
Option SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
Function Page
Reserved
Setting RMC
address
Reserved
Group channel
(x16)
Group address
Indication
and details
Indication Details Indication Details Indication Details Indication Details
1
0
No RMC
address
RMC1 0 to 2 RMC2 0 to F
1
RMC
address
setting
mode