Samsung AC200KNHPKH - Page 27

Samsung Electronics 3-19
No. Parts Procedure Remark
10 BRACKET MOTOR 1) Remove 2 screws on the base.
(using "+" screwdriver or electric motion
driver)
11 CONTROL BOX 1) Pull out all the connector on the pcb
board.
Warning : Make sure the power is
disconnected before work
2) Remove the screw that fix comp power
wire.
(using "+" screw driver or electric motion
driver)
3)
Remove the screw that fix comp power
wire.
(using "+" screw driver or electric motion
driver)