Samsung AM***FN*D series - Providing Information for User; User Operation Guidance; Troubleshooting; LED Display Error Codes

45
A
ENGLISH
After finishing the installation of the air conditioner, you should explain the following to the user.
Refer to appropriate pages in the user & installation manual.
1
How to start and stop the air conditioner
2
How to select the modes and functions
3
How to adjust the temperature and fan speed
4
How to adjust the airflow direction
5
How to set the timers
6
How to clean and replace the filters
Note When you complete the installation successfully, hand over the user & installation
manual to the user for storage in a handy and safe place.
Providing information for user
X
If you turn off the air conditioner when the LED is flickering, the LED is also turned off.
X
If you re-operate the air conditioner, it operates normally at first, then detect an error again.
X
When E108 error occurs, change the address and reset the system.Ex.) When address of the indoor
unit #1 and #2 are set as 5, address of the indoor unit #1 will become 5 and indoor unit #2 will
display E108, A002.
Troubleshooting
X If an error occurs during the operation, an LED flickers and the operation is stopped except the LED.
X If you re-operate the air conditioner, it operates normally at first, then detect an error again.
LED Display on the receiver & display unit
Detection of errors
LED Display